![]() ![]() Sets the buffer size, in bytes, for constant bit rate (CBR) encoding. The H.264 encoder supports the following modes in Windows 8: The following properties require Windows 8. Internally, the encoder converts this property to an AVEncVideoEncodeQP value. Changes are applied starting at the next input frame. In Windows 8, this property can be set at any time during encoding. The encoder ignores changes after the output type is set. To set this parameter in Windows 7, set the property before calling IMFTransform::SetOutputType. To set this parameter, set the property before calling IMFTransform::SetOutputType. This property applies when the rate control mode is quality-based VBR ( eAVEncCommonRateControlMode_Quality). The default mode is unconstrained variable bit rate (VBR). ![]() The following properties are supported in Windows 7. It supports the following properties.įor the codec requirements for HCK encoder certification, see the Certified Hardware Encoder section below. The H.264 encoder implements the ICodecAPI interface for setting encoding parameters. This attribute contains the sequence header. The default value is 1:1.Īfter the output type is set, the video encoder updates the type by adding the MF_MT_MPEG_SEQUENCE_HEADER attribute. For more information about profile and level constraints, refer to Annex A of ITU-T H.264. The encoder can derive the proper level for a given video stream, taking into account the format constraints and the characteristics of the video. It is recommended not to set the level in the media type, and allow the encoder to select the level. The default value is –1, indicating that the encoder will select the encoding level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |